Don's Music City - Pots and Control Sets


EMG Battery Bag Battery bag great for insulating the battery inside the instrument. (read more...)	Price: $10.00	CALL TO ORDER

EMG CS-89VT-SPL Control Set - Push/Pull Volume Control Set, Volume(push/pull) and Tone, Split Shaft. These controls are used for the EMG-89 or any of EMG's twin pickups that will allow you to coil tap. This includes the EMG-35TW, EMG-40TW, EMG-45TW and the EMG-MMTW . The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $10.00 On Sale For: $8.00	CALL TO ORDER

EMG CS-89VT-SPL-LS Control Set - Push/Pull Volume Control Set, Volume(push/pull) and Tone, Split Shaft, Long Shaft. These controls are used for the EMG-89 or any of EMG's twin pickups that will allow you to coil tap. This includes: EMG-35TW, EMG-40TW, EMG-45TW and the EMG-MMTW . The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $14.00 On Sale For: $11.00	CALL TO ORDER

EMG CS-VT-SOL Control Set - Solid Shaft Control Set, Volume and Tone, Solid Shaft. The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $10.00 On Sale For: $8.00	CALL TO ORDER

EMG CS-VT-SOL-LH Control Set - Left Handed Control Set, Volume and Tone, Solid Shaft, Left Handed. The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $10.00 On Sale For: $8.00	CALL TO ORDER

EMG CS-VT-SPL Control Set - Split Shaft Control Set, Volume and Tone, Split Shaft. This is the standard control set that comes with most EMG pickups. The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $10.00 On Sale For: $8.00	CALL TO ORDER

EMG CS-VT-SPL-LH Control Set - Left Handed Control Set, Volume and Tone, Solid Shaft, Left Handed The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $10.00 On Sale For: $8.00	CALL TO ORDER

EMG Dual Mode Switch Kit The DMSK uses a series capacitor to cut the low frequency of a pickup, simulating a single coil sound. This technique helps maintain the output of the pickup throughout the rest of the frequency response range. The tone of the low frequency response can be tailored to your requirements through the ability to choose different capacitor values. We suggest you start by using the .0047 and then adjust up or down if necessary. (read more...)	Regular Price: $29.99 On Sale For: $21.00	CALL TO ORDER

EMG Quik Connect Cable EMG-CBL-QC Quick Connect Cable. Replacement part needed to install most EMG pickups. Available in 3-pin or 5-pin. (read more...)	Regular Price: $6.50 On Sale For: $6.50	CALL TO ORDER

EMG-12B Stereo Jax w/ Battery Clip EMG-12B w/ Battery Clip Set (read more...)	Price: $5.50	CALL TO ORDER

EMG-12B Stereo Output Jax EMG-12B Stereo Output Jax (Standard) (read more...)	Price: $3.50	CALL TO ORDER

EMG-152B Stereo Output Jax Long Panel The EMG-152B Jax are standard 2 and 3 conductor phone jacks with extra long threaded bushing for mounting in panels/chassis up to 1.25in. thick. Long metal bushing virtually eliminates hum pick-up, and is ideal for microphone connections. Specifications Mounting Bushing: Brass, Nickel plated with attractive knurled flange. Insulation: Insulating spacer - XXP paper base phenolic. Insulator/ Spring Mount - Nylon. Springs: Special alloy nickel silver. Terminals: Tip - Nickel silver. Ring - Nickel silver. Hardware: One nickel plated brass hex nut, One nickel plated brass flat washer. (read more...)	Price: $18.00	CALL TO ORDER

EMG-25K Push/Pull Pot 25K Push/Pull Pot. Can be used as Volume or Tone control. The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. (read more...)	Price: $8.00	CALL TO ORDER

EMG-25K Push/Pull Pot - Long Shaft 25K Push/Pull Pot. Can be used as Volume or Tone control. The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. (read more...)	Price: $8.00	CALL TO ORDER

EMG-A25KX2 Dual Volume Pot Stacked Dual concentric volume pot (Stacked) (read more...)	Price: $13.25	CALL TO ORDER

EMG-BAL Balance Control Pot Balance Pot: Dual Gang. Solid Shaft 25K Ohm Linear Taper (read more...)	Price: $14.00	CALL TO ORDER

EMG-CS-VT-SPL-LS Control Set - Split Shaft, Long Shaft Control Set, Volume and Tone, Split Shaft, Long Shaft. These controls are used for carved top guitars that require a longer thread to pass through the body of the guitar. The controls included with EMG Systems are 25K Ohm, Audio Taper. This value of Pot is required for the system to work correctly. A 250K or 500K volume or tone pot will not work properly. The capacitor is .1 micro farad, this value gives the correct amount of high-end roll off. One way to change the high-end roll off point, add a second .1 micro farad in parallel. (read more...)	Regular Price: $10.00 On Sale For: $8.00	CALL TO ORDER